| Flooring Radiant Panel |
ASTM E648; NBSIR 75 950; NFPA 253, Critical Radiant Flux |
.73W/cm², Class I |
| Resistance to Light Fading |
lSO |
6 - 7 good (indoor use) |
| Residual Indentation |
EN 433 |
.04mm |
| Abrasive Wear, Frick Taber |
EN 660 - 2 |
2 mg/1.5mm |
| Abrasive Wear, Taber 1000 gm weightto wear layer penetration (end point) |
H-18 wheels |
>>25,000 cycles |
| National Floor Safety Institute Test |
www.nfsi.org |
High Traction >0.60 Certified |
| Static Coefficient of Friction |
ASTM C-1028-89 dynamometer pull method |
.80 wet |
| Impact Noise Reduction |
ISO 717-2 |
>13 dB |
| Shore Hardness |
94 |
| Static Load Limit |
DIN 16961.2 |
>350 lbs/in2 |
| Volume Resisitivity |
NFPA 99 |
<2x1011 ohms (not waxed) |
| Chemical Resistance |
Very good to most diluted acids, alkalis and common detergents. Some solvents can swell or dissolve vinyl. (Request detailed information from manufacturer). |
| Staining or permanent discoloration |
Not resistant to rubber (yellowing from certain antioxidants, oil based grease, tar based asphalt, lipstick |
| Euro-flex™ FSD HT tile meets or exceeds requirements of Federal Specification LF-475A and SST 312b for dimensional stability, flexibility, resistance to reagents and residual indentation. |
