| Flooring Radiant Panel |
ASTM E648; NBSIR 75-950; NFPA 253, Critical Radiant Flux |
0.73 W/cm², Class I |
| Smoke Density |
ASTM E-662, NFPA 258 |
<450 Average density in burning / smoldering mode |
| Residual Indentation |
Residual Indentation DIN 51955 25 hrs.) |
<.15mm (.0059") |
| Bending Resistance |
1cm mandrel DIN 51949 |
no cracking |
| Abrasive Wear |
EMPA |
.05mm |
| Resistance to Light Fading |
ISO |
6 7 good (indoor use) |
| Point load resistance |
DIN 5`955 |
>.15mm (.0059") |
| Static Coefficient Of Friction (www.nfsi.org) |
B101.1 ANSI/NFSI Standard Test Method for Measuring Wet SCOF |
High Traction >0.60 Certified |
| Static Coefficient of Friction |
GPHSZ 032 dynamometer pull method |
dry surface 0.7
wet surface 0.6 |
| Shore Hardness A |
75 |
| Static Load Limit |
DIN 16961.2 |
<350 lbs/in² |
| Thermal conductivity |
DIN 52612 (Heat transfer coefficient) |
.35K/cal/h/ °C
(172.5Kcal/m² °C) |
| Dimensional Stability |
DIN 51962 directional and cross directional shrinkage |
<.1% |
| Rolling castor chair test |
DIN 54324 |
passes |
| Chemical Resistance |
Very good to most diluted acids, alkalis and common detergents.Some solvents can swell or dissolve vinyl.(Request detailed information from manufacturer). |
| Not resistant to rubber (yellowing from certain antioxidants, oil based grease, tar based asphalt, lipstick cause permanent staining or discoloration. |
| Safefloor Guard meets or exceeds requirements of Federal Specification LF-475A and SST 312b for dimensional stability, flexibility, resistance to reagents and residual indentation. |
| Short Form Specifications |
Staining or permanent discoloration Not resistant to rubber (yellowing from certain antioxidants, oil based grease, tar based asphalt, lipstick |
